Etac Molift Mover 180 Operatör El Kitabı - Sayfa 5
Kaldırma Sistemleri Etac Molift Mover 180 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Etac Molift Mover 180 16 sayfaları. Electric patient lift
Ayrıca Etac Molift Mover 180 için: Hızlı Başlangıç Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (6 sayfalar)
Sayfayı Yazdır
• Insert the battery into the holder on the
column with the two battery terminals facing
downwards. Run the empty lift up and down
a few times to make sure that it is working
proerly. (The batteries should always be charged
prior to use.)
• Install the suspension as shown in pictures
below. Align supension in fork. Insert locking
pin. Make sure locking pin is properly fastened.
BM08101 Molift MOVER 180 English - Rev C 19.12.2013
Dismantling
• Remove the suspension.
• Run the lifting arm into its lowest position.
• Remove the hand control and battery from the
lift to prevent it from falling out in transit.
• Remove both Allen screws on the front and rear,
and remove the column.
Take care to ensure that your feet and arms do
not get caught when the column and lifting
arm are being lowered.
Storage and transportation
- Storage: For long time storage it is
recommended that the battery is removed and
the emergency stop button is activated. The
lifter can be stored and transported under the
following conditions:
• Pressure: 70 - 106 kPa
• Humidity: 15 - 93 %
• Temperature: -25 - 70 °C
- The lifter is designed for use at standard room
temperatures (+5 to +40°C). Following storage
or transport at other temperatures leave the
lifter in a room with a suitable temperature until
it reaches a safe operating temperature.
Page 5 of 16