Etac Molift Mover 180 운영자 매뉴얼 - 페이지 5

{카테고리_이름} Etac Molift Mover 180에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Etac Molift Mover 180 16 페이지. Electric patient lift
Etac Molift Mover 180에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (6 페이지)

페이지 인쇄

• Insert the battery into the holder on the

column with the two battery terminals facing

downwards. Run the empty lift up and down

a few times to make sure that it is working

proerly. (The batteries should always be charged

prior to use.)

• Install the suspension as shown in pictures

below. Align supension in fork. Insert locking

pin. Make sure locking pin is properly fastened.

BM08101 Molift MOVER 180 English - Rev C 19.12.2013

Dismantling

• Remove the suspension.

• Run the lifting arm into its lowest position.

• Remove the hand control and battery from the

lift to prevent it from falling out in transit.

• Remove both Allen screws on the front and rear,

and remove the column.

Take care to ensure that your feet and arms do

not get caught when the column and lifting

arm are being lowered.

Storage and transportation

- Storage: For long time storage it is

recommended that the battery is removed and

the emergency stop button is activated. The

lifter can be stored and transported under the

following conditions:

• Pressure: 70 - 106 kPa

• Humidity: 15 - 93 %

• Temperature: -25 - 70 °C

- The lifter is designed for use at standard room

temperatures (+5 to +40°C). Following storage

or transport at other temperatures leave the

lifter in a room with a suitable temperature until

it reaches a safe operating temperature.

Page 5 of 16