Clockaudio CDT100 Kullanıcı Kılavuzu - Sayfa 8

Aksesuarlar Clockaudio CDT100 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Clockaudio CDT100 17 sayfaları. Dante transporter
Ayrıca Clockaudio CDT100 için: Kullanıcı Kılavuzu (16 sayfalar)

Sayfayı Yazdır

4 – Device Configuration

There are two parts of the device that require software to setup:

1. The audio routing.

2. The configurable features of the device itself.

The audio routing should be carried out using Audinate's Dante Controller, available for Windows and Mac OS X from the Audinate

website www.audinate.com along with instructions on how to use the software and setting up routes on a Dante network.

Dante Controller is a free software application that enables you to route audio and configure devices on a Dante network.

With automatic device discovery, one-click signal routing and user-editable device and channel labels.

See the overview link for more details on

Features:



View all Dante-enabled audio devices and their channels on the network..



View and edit device clock and network settings



Route audio between devices, and view the state of existing audio routes



Rename devices and channels using your own friendly names



Customize the receive latency (latency before playout)



Save and reapply audio routing presets



Edit presets offline, and apply as configurations for new network deployments



Change sample rates and clock settings



View multicast bandwidth across the network



View transmit and receive bandwidth for each device



View device performance information, including latency stats, clock stability stats and packet errors



View comprehensive, configurable event logs

4.1 - IP Address Setup

Important Notes:

 When using Dante controller, the CDT100 will be shown using a default device name of CDT100-###### where '######' is the

last six characters of the devices MAC address.

 Failure to correctly configure IP addresses will not allow an CDT100 device to correctly authenticate in the software and while it

will show up in Dante Controller. The input and output channels won't be visible and routing of audio to and from the CDT100

will not be possible.

In order to configure an CDT100 both to set up its internal parameters and also setup audio routing, the PC will need to be able

to communicate with it over the network.

While all Dante devices will be discovered regardless of the IP address setup on the PC, communication can only occur if the PC

and the device have compatible IP addresses.

By default, CDT100 is set to get a dynamic IP address. As with all Dante devices, if the CDT100 device does not find a DHCP server

to retrieve an IP address from, it will give itself an automatic private IP address (APIPA) instead.

An APIPA is always in the range 169.254.x.y.

To ensure communication, the PC can either be set to get a dynamic IP address, or be given a static IP address in the range

169.254.x.y. The PC may require a restart for the changes to take affect.

Further information on IP setup for an audio system using Dante can be found in the FAQ's on the Audinate website

(https://www.audinate.com/resources/faqs).

Clockaudio 2015

Dante audio

networking.

CDT100 User Manual