Akrobat XCITYX FLAT Kurulum ve Kullanım Kılavuzu - Sayfa 4

Spor & Kamp; Açık Hava Akrobat XCITYX FLAT için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Akrobat XCITYX FLAT 9 sayfaları. 17 x 12 ft

Sayfayı Yazdır

Fitting the mat and installing the springs

Lay the mat flat inside the frame. Make sure the logo is facing upwards. In order to make the

installation of the jumping mat easier, locate the four rings in the corners of the jumping mat

and attach four springs on these locations first. Pass the springs through the spring loops on

the corners underside of the jumping mat.

Continue by attaching springs from the corners to the middle of the jumping mat until all

springs are attached.

At first, it may look like the mat won't fit, it will however stretch to the correct size when you finish

attaching all springs. Attach springs simultaneously on both sides of the frame (one person at

each side).

Important: Be sure all spring hooks

are well attached to the frame.

AKROBAT HINT:

Springs can be hard to attach, you will need a little force. Help yourself by using

spring tool which is included in the kit. Do not forget to wear gloves!

INSTALLATION AND USER MANUAL - XCITYX FLAT 17 x 12 ft

Important: Be sure that you hook

the corner spring trough the loop in

the corner. It will keep the corners

of the mat in place.

Digging the trampoline pit

Position the frame on the location you chose and mark the position on the ground. It's best to mark

out a hole a bit wider than the diameter of your trampoline.

This will make it easier for you to put the frame in and find the right level. Dig the pit to the

following dimensions:

TRAMPOLINE SIZE 17x12ft (518 x 366 cm)

Dimension A:

OUTSIDE PIT

530 x 380 cm / 17'4'' x 12'5''

478 x 326 cm / 15'7'' x 10'7''

25 cm

/ 10''

20 cm

/ 8''

The hole should not accumulate water (in which case the drainage is necessary) and it should be

possible to clean during maintenance.

First, dig the outer hole to create a ledge for

your trampoline frame, which needs to be

25 cm / 10'' deep. This is the exact frame height,

so that the safety pad on top of the frame will

be just above the grass level. Continue by

digging the inner hole.

AKROBAT HINT:

It's a relatively easy task to hand dig the hole for smaller size trampolines, but it would

be best to hire a mini digger to excavate most of the soil and leave you with the finishing

touches.

Note: You will need to save some of the soil for later.

Dimension B:

Dimension C:

INNER HOLE

TOTAL DEPTH

120 cm / 3'9''

25 cm / 10''

20 cm

/ 8''

Dig the inner hole according to the dimensions

of your trampoline and with a bowl-shaped

bottom. The inner hole should be 40 cm / 1'4''

narrower than the trampoline size. This will

leave a 20 cm / 8'' ledge all around on which

the trampoline will sit.