ASG X-PAQ ASG-NW2500-EIP Kullanıcı Kılavuzu - Sayfa 7
Kontrol Ünitesi ASG X-PAQ ASG-NW2500-EIP için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ASG X-PAQ ASG-NW2500-EIP 15 sayfaları. Ethernet ip network communication module
Sayfayı Yazdır
Overview:
The AQ wireless can be equipped with a network card that provides connectivity to a
Plant Floor Control System using Ethernet IP. This interface includes a network
card, a human-machine interface (LCD display & keypad), an additional serial port,
and an RJ45 network connector.
Human-Machine Interface:
the user to enter program menus. These program menus allow access to settings
that govern how the Ethernet IP interface functions.
Network Connector (RJ45):
The Ethernet port is used to transmit and receive TCP/IP messages that are format-
ted to comply with Ethernet IP.
Serial Port (MIF):
DSUB 9 PINOUT
2 - RX
3 - TX
5 - GND
Operating Mode:
The human machine interface (HMI) consists of an 2-line by 16
character backlit LCD display and a six button keypad. During
power-up, the display on the HMI will display the firmware ver-
sion contained inside the microprocessor's memory.
During operation, the HMI will show the unit's IP address.
The HMI is also used during the programming phase allowing
The additional serial port on this unit is a debugging port. This
port will give the user direct access to the network module. A ter-
minal program is all that is necessary to use this port. The set-
tings for the terminal program should be 38400 baud, 8-bit, no-
parity, and 1 stop bit.
When the Ethernet IP network interface powers up, the display
briefly shows the firmware version information and then the
unit enters it's operating mode.
In the main operating mode, the display will show the unit's IP
address. From this main screen the user can press the ENT key
to enter the programming mode.
7