Cypress CY4532 EZ-PD CCG3PA Hızlı Başlangıç Kılavuzu

Anakart Cypress CY4532 EZ-PD CCG3PA için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cypress CY4532 EZ-PD CCG3PA 2 sayfaları. Evaluation kit

Cypress CY4532 EZ-PD CCG3PA Hızlı Başlangıç Kılavuzu
CY4532 EZ PD
STEP
Unpack the kit contents. The CY4532 EVK helps to evaluate Cypress's EZ-PD
USB Type-C Power Adapter (PA) and USB Type-C Power Bank (PB) applications. The EVK is con gured
1
for the PA application by default. Follow steps 2 and 3 to evaluate this application.
CY4532 EVK Power Board
Note 1: The EVK is shipped with the Main Board pre-mounted on the Power Board. No further assembly
required.
Note 2: While the USB Type-C Power Adapter application is meant for AC/DC charging, this EVK hardware
uses DC/DC regulators as the power source for safety reasons.
Note 3: This document uses board images with Rev06 of the hardware. Actual hardware revision
may be higher.
STEP
Verify that the jumper settings on the boards match the settings in the table/image below.
CY4532 EVK Power Board
2
J6, J7, J9 & J14
Short pins 1 & 2
Verify that the Input Power Selection Switch (SW1) is set to the DC Input position. Connect the AC/DC
power adapter (provided with the kit) to the DC Power Jack (J3) of the CY4532 EVK Power Board. Plug
the other end of the power adapter into an AC power socket. The Power LED (LED1) on the CY4532 EVK
Power Board glows green to indicate that the kit is powered.
J4 Load Terminal (Type-C Sink)
J2 DC Terminal
J3 DC Power Jack
LED1 Power LED
J14 Power LED Enable Jumper
SW1 Input Power Selection Switch
J1 Battery Terminal
(for PB application only)
J6 & J7 VCONN Mode Selection Jumpers
J5 Load Terminal (for PB application only)
CY4532 QUICK START GUIDE
CCG3PA EVALUATION KIT EVK
CY4532 EVK Main Board
J5 & J7
Open
CY4532 EVK Power Board
CY4532 EVK Main Board
J2, J3, J4 & J6
Short pins 1 & 2
CY4532 EVK Main Board
J5 & J7 Firmware (FW) Download
Mode Jumpers
U1 CCG3PA Controller
(CYPD3171-24LQXQ)
J9 USB Type-A Source Port
J2, J3 & J4 Application
Mode Selection Jumpers
J6 CCG3PA Current
Measurement Jumper
J10 USB Type-C Source/Sink Port
J9 AXRES Isolation Jumper
CCG3PA Controller for
12 V 50.4 W AC/DC
Power Adapter