EGB 683 625 Kullanıcı Kılavuzu - Sayfa 8

Uzaktan Kumanda EGB 683 625 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. EGB 683 625 16 sayfaları.

Sayfayı Yazdır
EGB 683 625 Kullanıcı Kılavuzu
Operation of daylight sensor
1.
During remote control settings, press the
2.
Change the lux value
3.
Change the lux value
4.
Press
to save the settings
5.
Press
to send the stored setting to the sensor, the product that contains the sensor will
blink 1x to confirm receipt.
Note!
This feature is turned off by default and can only be changed when you press the
settings view.
During activation of this setting, only a standby dim time of indefinite time is possible.
See image 02 for clarification of this function.
Corridor fuction (img.02)
This is a 3step dimming function within the sensor and works as follows:
1.
Lamp is off because there is enough ambient light (even if motion is detected).
2.
If there is less ambient light than the set lux value
turn on at the selected brightness level (brightness %) and stays on as long as it detects
movement.
3.
When the product detects no movement anymore and the selected hold time expires, it
switches to standby mode (set "standby" time and dimming level)
4.
After the selected "standby" period elapses, the product will turn off.
Corridor fuction (img.02)
With sufficient natural light, the
light does not switch on, even
when
presence is detected.
Difference between Daylight sensor mode and corridor mode
The difference lies in turning on and off. In the corridor mode, the sensor will trigger (turn on) the
product whenever motion is detected, while in the daylight sensor mode the amount of light deter-
mines when to trigger the product. In the daylight sensor Mode, the product will therefore turn on
when it gets dark, even though there is no movement detection. See image 03 and 04 for a graphic
explaining the difference.
to set when the product should turn on during the day.
to set when the product should automatically go out.
With insufficient natural light,
the sensor switches on the light
automatically when presence is
detected.
icon to activate the additional daylight mode.
then the product will
When no presence is detected
anymore and after the hold-
time expired, the light dims to
stand-by level if the surrounding
natural light is below the daylight
threshold.
8
eltric K. Heckel GmbH
Weiherstraße 29
D-95448 Bayreuth
www.eltric.com
EN
NL
button during
Light switches off automatically
after the stand-by period
elapses.
D