ambiance HC-669 Kurulum ve Güvenlik Talimatları - Sayfa 2

Transformatör ambiance HC-669 için çevrimiçi göz atın veya pdf Kurulum ve Güvenlik Talimatları indirin. ambiance HC-669 2 sayfaları.

Sayfayı Yazdır

INSTALLATION (CONTINUED)

INSTALLATION OF 120V QUICK CONNECT PLUG

1. Cut off end of 120v cord cleanly and evenly. CAUTION: Do

not separate wires. Do not remove or damage

insulation (Figure 2).

2. Press cord, with ridged side to the right (tracer wire),

down and into front of plug.

3. Press cord down onto metal prongs.

4. Slide plug cover over cord and plug until plug cover is

centered over plug.

INSTALLING SWITCH ON 120V CORD

NOTE: Switch must be mounted a least 1 1/2" away from

any metal parts.

NOTE: When parallel wire (SPT II) is used, the tracer wire

is square shaped or ridged and the non-tracer wire is

round in shape or smooth (seen best when viewed from

wire end).

1. Split 120v cord as illustrated (FIGURE 3). Cut the

non-tracer (or smooth) wire. Be sure to cut only the

smooth non-tracer wire.

2. Remove the screw from the switch and take the switch

apart.

3. Place the wires in part A (without the wheel) as shown.

Tuck the cut wire down one end on each side of the

barrier.

4. Press both halves of the switch back together. Note that

the points pierce insulation to make contact with copper

inside wire.

5. Place screw back into center hole and secure in place

with nut.

LOW VOLTAGE OUTPUT CONNECTIONS (12vac)

HC-669

Insert plug from 9836 fixture or 9858 disk lights (not included)

into transformer plug outlet.

IMPORTANT SAFETY INSTRUCTIONS

This transformer has a polarized plug (one blade is

wider than the other). As a safety feature, this plug will fit

in a polarized outlet only one way. If the plug does not

fit fully in the outlet, reverse the plug.

If it still does not fit, contact a qualified electrician. Never

use with an extension cord unless plug can be fully

inserted. Do not attempt to defeat this safety feature.

FINAL ASSEMBLY

To control transformer, install ON/OFF switch or good quality

low voltage electronic dimmer on the 120V side of

transformer.

DO NOT NAIL OR SCREW THROUGH CABLE TO ATTACH

TO A SURFACE. Use 9430 sleeving to cover wire when going

through holes in combustible materials, or notch the cabinet

wall.

NOTE: As with all electronic transformers, there is a

potential for Radio Frequency Interference (R.F.I.). To

reduce R.F.I., rotate the electronic transformer in relation

to the input line, or switch to a magnetic

transformer.