amc VIBRO AVM 1002D Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Вимірювальні прилади amc VIBRO AVM 1002D. amc VIBRO AVM 1002D 14 сторінок. Vibration monitoring system with relay outputs
Друкувати сторінку
Picture 8-1 // Functions of configuration switches
Example:
Monitoring of the RMS of the vibration signal velocity, using 3 Hz high pass filter and 10 KHz
low pass filter, for 100 mm/s range and internal power loop.
The following configuration of the switches must be set:
SW1
SW2
OFF
ON
OFF
OFF
OFF
ON
OFF
ON
OFF
OFF
OFF
ON
ON
OFF
1
8
1
6
WARNING!
The set-up of the switches configuration should be done on a switched off device. If the set-up
was done on an operating module, it needs to be restarted in order to activate the new
configuration.
12
AV MONITOR 1002D