Ameda HygieniKit Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Молоковідсмоктувач Ameda HygieniKit. Ameda HygieniKit 14 сторінок. One-hand manual breast pump, milk collection system with one-hand breast pump adapter and flexishield areola stimulators
Також для Ameda HygieniKit: Інструкції з експлуатації та чищення (2 сторінок)
Друкувати сторінку
If suction is low:
• Check that valve(s) is/are pushed onto breast flange(s).
• Check valve(s) for tears or stretches. Replace if needed.
• If single pumping, check tubing adapter to be sure side not in use is closed.
• Check tubing adapter for cracks. If seen, replace.
• Set pump to higher SUCTION/VACUUM setting.
The valves are vital for proper suction. To work well, they must be intact and look closed
when pump is not in use.
To prolong valve life:
• When removing from breast flange, pull gently from thick sides, not thin edge.
• Do not stick anything into valves during cleaning. Just swish them around in warm, soapy
water, rinse well in warm water, and air dry.
Converting to an Ameda One-Hand Manual Breast Pump
ALWAYS WASH HANDS WELL WITH SOAP AND WATER BEFORE PUMPING.
Assembly
Use this section if your One-Hand handle assembly is part of an Ameda HygieniKit or has
been purchased separately.
Remove plastic covering on handle assembly.
3. Push piston into
upper chamber
of flange.
1. Unsnap and remove adapter cap.
2. Remove diaphragm from upper chamber of breast flange.
4. Pull handle down
and snap handle
collar around
bottom of flange.
(See shaded area
in diagram above.)
5. Screw flange
onto bottle.
Handle is on
correctly if top
of handle is a
straight line.
7
E N G L I S H