Astonica 50105532 Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Внутрішнє оздоблення приміщень Astonica 50105532. Astonica 50105532 2 сторінки.
Друкувати сторінку
PARTS & HARDWARE LIST
PART #
DESCRIPTION
A
Chair Seat
B
Chair Base
C
Back Cross Bar
D
Long Bolt
E
Short Bolt
F
Hex Wrench
G
Plastic Bolt Cap
H
Metal Washer
Parts Detail
A
E
D
H
F
G
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
NOTE: This product is intended for residential, non-commercial use.
QUANTITY
6
6
6
24
12
1
12
36
C
B
Finished Assembly
1
ASSEMBLY INSTRUCTIONS
1. (SEE FIGURE 1) Lay chair seat (A) face
down on a non-abrasive surface to
prevent scratching frame.
2. (SEE FIGURE 2) Lay chair frame (B)
on top of chair seat (A).
CAUTION: Do not over tighten fasteners
3. (SEE FIGURE 3) Attach front of
chair seat (A) to base (B) secure using
long bolts (D) and washers (H)
and tighten slightly.
4. Attach rear of chair seat (A) to base (B),
secure using long bolts (D) and washers (H)
and tighten slightly.
5. (SEE FIGURE 4) Attach back cross bar (C)
to chair base using short bolts (E)
and washers (H).
6. Tighten all bolts, alternate from one bolt
to the next turning each bolt approximately
five times before moving to the next bolt.
7. Lift assembled chair upright and ensure
all bolts are secure using hex wrench (F).
8. Install bolt cap (G) over short bolts (E).
Figure 1
A
Figure 2
B
Figure 3
D, H
B
D, H
Figure 4
2
A
A