Doodle Labs Smart Radio Посібник з усунення несправностей - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник з усунення несправностей для Мережеве обладнання Doodle Labs Smart Radio. Doodle Labs Smart Radio 16 сторінок. Advanced mimo mesh router for resilient private wireless networks
Друкувати сторінкуSmart Radio Trouble-Shooting
Guide
before a crash or a reboot, please do so. You will need to
print the kernel messages and system logs with
root@smartradio:/# dmesg
root@smartradio:/# cat /var/log/messages
The Smart Radio also includes a utility to do a comprehensive save of the system state
root@smartradio:/# sysutils savelog
The results will be stored in
host machine by running
user@host-pc:~$ scp root@<IP ADDRESS>:/tmp/savelogs.tar.gz ./
Send this file along with your technical support request.
Factory Resetting
Configuration backup, restoration and factory resetting can be performed by navigating to the
page
system → backup/flash firmware
such that you can no longer access it, you can also factory reset the radio without network
access. Factory reset differs from radio to radio.
In general, the factory reset pin should be pressed or pulled to ground for between 5 and 30
seconds (no more than 30 seconds and no less than 5 seconds). Factory reset only works after
the device has fully booted up. Power up the device and wait for assurance, wait for 3 minutes
for the radio to fully boot. The location of the factory reset switch is described below.
Note that if the device cannot be restored to it's factory reset state using this method, then it is
possible that the device needs to be repaired by Doodle Labs. Contact
Embedded Radio (-2H)
The -2H radio includes a reset wire on the main connector which should be pulled to ground
following the recommended timing.
Embedded Radio (-2J-*M)
Look for a pin hole on the front side of the unit. Insert a pin through the hole and press the
tactile switch following the recommended timing.
External Radio (-2J-*E)
The External radio includes a reset pin inside the box which should be pressed following the
recommended timing.
© 2021 Doodle Labs. All rights reserved.
/tmp/savelogs.tar.gz
. If you have modified your network configuration
Page 15
SSH
into the radio. After that, you can
. You can copy this file to your host your
September 8, 2021