DoorKing 1601 Series Посібник з монтажу - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автоматичні шлагбауми DoorKing 1601 Series. DoorKing 1601 Series 11 сторінок. Break-away octagon arm installation kit
Також для DoorKing 1601 Series: Посібник користувача (8 сторінок), Посібник (5 сторінок)
Друкувати сторінку
RUBBER BUMPER INSTALLATION
This rubber bumper is designed to install on a 14 ft aluminum octagon arm (not included) for a 1601 barrier gate operator.
It CANNOT be used with a 1602 or 1603 operators.
Installation
2
Slide on Rubber Bumper
The 3" trim end MUST side on first and the end
fits into the cover, see cover illustration.
Tip: Liquid soap will help rubber bumper
slide on easier.
Reinstall End Cap
3
Push a screwdriver through the hole in cap to release
spring while pushing cap on. Keep pushing cap on
until a "CLICK" is heard which locks it in place.
1601-269-G-7-21
1
Remove End Cap
Push a screwdriver through hole in bottom of end cap
to release spring while pulling cap off.
11
DoorKing Part Number
8080-089
Octagon Arm
Rubber Bumper
Cover
3" Trim End
Rubber Bumper
3" trim end MUST slide
on as shown.
120 S. Glasgow Avenue
Inglewood, California 90301
3" Trim End
U.S.A.