DOOVAC MVO-100 Інструкція з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Водяний насос DOOVAC MVO-100. DOOVAC MVO-100 11 сторінок. Vacuum pump
Друкувати сторінкуMaintenance guide
Oil injection, power connection, connect suction pipe
1. Product basic component
Nameplate
Inlet port
Vacuum oil
2. Oil injection
Unstop the oil inlet
Inject the product's particular oil
- Note : Oil standard chart
Fill up to "MAX" in an oil gauge.
- Note : Oil standard chart
Make sure to check the o-ring
in an oil inlet and reassemble
the parts.
Vacuum pump installation
Oil inlet
MVO-100
[ DM-F002 ]
[ DM-F002 ]
3, Connect the power
Disassemble the
electricity box's cover.
Check the wiring diagram
inside of the electricity box
and connect the wires.
After perforating the side of
the electricity box, connect
the power.
Check the rotation direction
of cooling blade.
Warning :
No match of voltage and frequency
will cause a severe damage to the
motor.
Warning :
A backlashing of the motor will
Cause a severe damage to vacuum
pump.
4. Connect suction pipe.
Remove the rubber stopper in
an inlet and Connect the suction
pipes.
Warning :
In case of any foreign substances
coming into the pump, it will
cause severe damages to rotor
and vane. In this case, installation
of an extra filter on suction pipe
is necessary.
LV.1~2
PF002
2/11