flying Thinz Mad 3D Taco Інструкція з експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка flying Thinz Mad 3D Taco. flying Thinz Mad 3D Taco 14 сторінок. An all out 3d fun fly plane

Друкувати сторінку

Mount the battery onto the vertical fuselage centered with the

leading edge of the wing. Cut slits on the top and bottom of the

battery location to pass the provided velcro strap through. Make

sure the battery leads can plug into the speed controller.

Install the motor and gearbox onto the motor mount. Using a

1/16" drill bit, make a hole to secure the gearbox to the motor

mount. Use a servo mounting screw to secure the gearbox to the

motor mount. DO NOT connect your motor wires to the wires on

the speed controller at this time.

Securely install the propeller onto the gearbox output shaft.

Follow the manufacturers recommendations for securing the prop

and prop nut to the shaft.

The final setup should ultimately look similar to the image above.

Make sure to secure your wires with hot glue or your preferred

method.

Finalize Radio Setup

Turn on your transmitter and connect the battery to the speed

controller. Center all servos using the transmitters trim or sub-

trim. Make any necessary adjustments on the EZ Connectors and

control rods to assure your control surfaces are perfectly lined up.

Make sure all the control surfaces operate in the proper direc-

tion for your control input.

Follow the manufactures instructions on setting up the speed

controller and motor/gearbox combination you have chosen for

your plane.

Attach the motor wires to the speed controller. Make sure

your throttle operates in the proper direction. Be extremely care-

ful with the prop when connecting the battery for the first time.

Throws & Center of Gravity

The throws should be set as high as possible on all control sur-

faces. Set a 50% dual rate on one switch as a bailout if you feel

the controls are too sensitive.

The CG should be 5 1/4" from the leading edge. Adjust the bat-

tery position to obtain a balancing point on or as close to the

location of the center of gravity.

Damage Repair

Repairing a damaged aircraft is easy and very quick. Usually,

you can be up and flying again within minutes of a severe crash.

Use 5 minute epoxy or hot glue to join any broken parts. Make

sure not to melt the foam with the hot glue gun.

If you bend your drive shaft, try straightening it out before

replacing it. We've bent a few shaft and have been able to bend

them back close enough to avoid vibrations.