flying Thinz Mad 3D Taco Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка flying Thinz Mad 3D Taco. flying Thinz Mad 3D Taco 14 сторінок. An all out 3d fun fly plane

Друкувати сторінку

Attach the aileron control rod wire through the control horn.

You may have to use a drill bit or X-acto knife to make the hole a

little bigger for the rod. Slip the wire through the hole in the EZ

connector and punch the control horn into the foam on the aileron.

Make sure the holes on the control horn are as close to the center

of the wing / aileron joint as possible.

Glue the horns in place. Add a small dot of glue on the

opposite side that protrudes from the control horn.

Use a few beads of hot glue to hold the wire in place.

Attach a control horn to one of the assembled carbon fiber rod

control arms. Run the other end through the EZ Connector on the

elevator servo. Line up the rod with the vertical fuselage and

punch the control horn through the foam as close to the joint

between the stab and elevators.

Glue the horns in place and place a small dot of glue on the

opposite side that protrudes from the control horn. Do not attach

the servo at this time.

Install the rudder control horn in the same manner as previ-

ous steps.

The elevator and the rudder servos should be lined up as

shown above. Use double sided tape or hot glue to hold the ser-

vos in place. Use beads of hot glue to hold the wires in place.

Install the receiver as far forward as the shortest servo wire

will allow. You'll have to make a hole in the vertical fuselage to

pass the wires from the other side to the receiver. When you route

your receiver antenna, try to keep it away from your servo leads.

Use double sided velcro tape to hold the receiver in place. Use

beads of hot glue to hold the wires in place.

Install your speed controller on the opposite side of the receiv-

er. Pass the wire to the receiver through the hold crated to pass the

servo leads through. Create another hold above the speed con-

troller to pass the battery connector through. Attach the speed

controller to the model with double sided velcro tape. Use beads

of hot glue to hold the wires in place.