flying Thinz Mad 3D Taco Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка flying Thinz Mad 3D Taco. flying Thinz Mad 3D Taco 14 сторінок. An all out 3d fun fly plane

Друкувати сторінку

Wing Assembly

Glue the two carbon fiber rods into the precut slots on the

back of the wing. Make sure to lay the wing on a flat level sur-

face before allowing the glue to set. Wipe off any excess glue

with alcohol and paper towels.

Install the wing into the vertical fuselage. Use t-pins and the

provided squares to attach the wing to the fuselage. Run a bead of

glue alone the top and bottom edges of the wing. Quickly move to

the next step before the glue sets.

Insert the motor mount into it's slot in the fuselage and into

the notch on the wing. Glue it in place making sure that motor

mount is centered with the fuselage. The motor mount should

help straighten the wing.

Put the Taco aside as the glue sets and move on to the next steps.

Preparing Control Surfaces

To prepare the control surfaces, you have to make a decision. If

you are going to hinge your control surfaces with regular hinges,

then the surface must be shaped as shown above for the 1/2A

Hinges.

If you prefer to use tape to hinge your control surfaces, then the

surfaces must be shaped as shown above for Taped Hinges.

Using #120 grit sandpaper on a sanding block, shape the edges

of your control surfaces as shown above for your preferred hing-

ing method. Make sure the correct edge on the control surface is

shaped by checking them against the wing or stab.

FlyingThingZ recommends taking the extra time and steps to

hinge your control surfaces with Dubro 1/2A Hinges (part# 118

or 119)

If you'd prefer to use the tape method, we recommend using

Dubro's Electric Flyer Hinge Tape (part#916)

Elevator Assembly

Dry fit the elevators onto the horizontal stab with the elevator

joiner between the two elevator halves. Make a mark on the

elevator joiner where it meets the second elevator. Cut the eleva-

tor joiner on the mark. Make sure to compensate for the outside

edges of the elevator that butt up against the horizontal stab.