flying Thinz Mad 3D Taco Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка flying Thinz Mad 3D Taco. flying Thinz Mad 3D Taco 14 сторінок. An all out 3d fun fly plane

Друкувати сторінку

Test fit the elevators with the joiner installed. Sand down the

joiner as necessary to get a good fit. Make sure the elevators are

not rubbing against the stab.

Using your preferred gluing method, join the two elevator

halves with the elevator joiner in place. Make sure to lay them on

a flat surface to assure they are perfectly level.

Put the elevator assembly aside as the glue sets and move on to the

next steps.

Finalized Assembly

Slide the horizontal stab through the back of the Taco. The fit

is extremely tight so be careful when inserting it. Once inserted,

make sure that the stab is fully seated in position before gluing.

Use the provided squares with t-pins to hold the assembly in place

as the glue sets.

Dry fit the horizontal fuselage on top of the wing. From the

bottom of the Taco, make a mark onto the horizontal fuselage

where the wing's leading edge and trailing edge meet. Do the

same for the horizontal stab. This is to assure you don't put glue

outside the wing area. Apply a liberal amount of glue to the hor-

izontal stab between your marks and glue into place. Use t-pins

to hold the assembly together as the glue sets.

Glue the skid plate onto the Taco's belly. Once the glue has set,

the Mad 3D Taco is ready to be painted.

Painting Tips

It's finally time to paint your Mad 3D Taco.

Before painting the model, make sure it it free of dust and oil. Use

alcohol and a lint free rag to rub off any oils or dust on the model.

Alternatively, you can use a tack cloth to remove dust.

FlyingThingZ recommends standard spray paint that can be

picked up at most hardware stores. There is one thing that you

should avoid when using spray paints. Make sure it does not con-

tain any rust inhibitors. Rust-O-leum and other paints with these

inhibitors will deteriorate the foam.

When applying the paint, use multiple light coats. Painting it on

too thick will add weight and create runs. Use the foam triangles

to test your paint before applying it on the Taco.

Other painting methods you can use are:

Permanent Colored Magic Markers

Latex Based Paint

Acrylic Based Paint

Airbrushing