Canor 8588008161760 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Canor 8588008161760. Canor 8588008161760 7 сторінок. Integrated tube amplifier
Друкувати сторінкуBACK PANEL:
•
LEFT / RIGHT SPEAKER OUTPUTS - 4 and 8 Ohm separated terminals.
•
MONOBLOCK OUTPUT - a pair of terminals only for monoblock set-up.
•
IN1, IN2, IN3, IN4 - left / right RCA inputs.
•
OUTPUT LINE FIX - fix RCA output.
•
XM1, XM2 - XLR input only for monoblock set-up.
•
C-LINK and MASTER/SLAVE switch - communication interface for monoblock set-up.
•
POWER - mains power inlet/mains switch with mains fuse.
Basic functions of reproduction
Plug the power cord in Virtus I2. Turn on the Virtus I2 with the Power Main switch, which is located on the back
panel. When you turn on the main switch, the Virtus I2 will be set into standby mode - the red LED diode on the
front panel lights up. After pressing the Power button (on the front panel or on the remote control) controlled
turning-on sequence gets initiated, which consists of cooling and preheating the tubes, thereby extending their life
span. The cooling cycle is also carried out when the unit is turned off, if the main switch on the back panel is not
turned off, i.e. after turning off via the button on the front panel, or via remote control, and a 45-second countdown
to cooling without indication begins. If you turn on the unit at this time, the cooling will continue and will be
indicated by a flashing red LED. When the cooling cycle is over then the main toroidal transformer gets connected
(the CANOR logo lights up), and then the slow start-up of voltage begins.
This cycle lasts 45 seconds and then the red LED stops flashing, an output relay connects the signal to the last
selected input if the main power supply does not get connected.
During the first turning on or disconnecting of the main power supply IN1 input gets preselected and the volume
level is set to -44dB. Volume is being set in 63 steps by 1dB. The highest volume is MAX dB, the lowest being -
63dB. Another step is MUTE. You can control the volume with a big control knob on the front panel. The volume
is being controlled by a relay attenuator with an accuracy of concurrence better than 0.05dB.
You can connect both 4- and 8-Ohm loudspeakers. The amplifier has separated terminals for each type.