Cansec MAP1 Конфігурація - Сторінка 3

Переглянути онлайн або завантажити pdf Конфігурація для Контролер Cansec MAP1. Cansec MAP1 12 сторінок.

Introduction

The MAP1 is factory set to DHCP mode when shipped and is recommended to leave it in

DHCP mode. First Access software will automatically find all connected controllers in the

local network. The MAP1 controller can optionally be set to a static IP address. Cansec

provides a software utility called MAP1 IP Configuration Tool which scans the network

for any connected MAP1 controllers and provides the option to change the IP addresses of

the MAP1 controllers. The utility is downloadable from cansec.com/downloads.

If there is no DHCP server present on the network, the MAP1 IP Configuration Tool is

not applicable. However, the USB IP Configuration Tool can be used to configure the IP

addresses of the MAP1 controllers.

Note: The static IP address should be a valid address obtained from the IT department.

 All 32 and 64 bit versions of the following Windows Operating Systems: Windows 7

Windows 8

, Windows 10

 See Microsoft's web site for CPU, RAM and disk space requirements for the

aforementioned operating systems

 Network adapter – If using MAP1 IP Configuration Tool

 A computer USB port – If using USB IP Configuration Tool

 A USB flash drive, formatted as FAT32 (most flash drives are formatted as FAT32) – If

using USB IP Configuration Tool

 A text editor – If using USB IP Configuration Tool

, Windows 2008

, Windows 2012

MAP1 IP Configuration

and Windows 2016

Page 3 of 12

July 2021 • Rev. 1.2