Baumer IO-Link RR30 Інструкція з експлуатації - Сторінка 20

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари Baumer IO-Link RR30. Baumer IO-Link RR30 40 сторінок. Radar sensor

4.3.8.2 SSC4 Behavior

By enabling auto reset, a full-featured counter being able to count lot sizes can be created without any need

of a manual reset.

Time filters like Response Delay can help to optimize the timing of the execution of a subsequent actor.

Figure 22 illustrates the behavior of SSC4 using different setting. SSC4 source is hereby the switch counter

of SSC1.

Figure 22: Behavior SSC4/Counter: Single-Point or Window, Auto reset enabled or disabled

auto

4.4 Teach Channel Selection & Teach Status

The described teach commands can be applied to individual switching signal channels. Before proceeding

with the teach-in procedure, make sure to select the SSC that should be addressed.

Furthermore different information are available to indicate the current mode and teach-in state of the

selected switching signal channel to help to execute the right commands described in section Fehler!

Verweisquelle konnte nicht gefunden werden. and Fehler! Verweisquelle konnte nicht gefunden

werden..

Parameter name

TI Select

TI Info.Mode of TI Select

TI Result.State

en_BA_RR30_IO-Link_V0.23.docx

13.01.2021/

Pulse: only negative pulses are

prolonged

Short Description

Selection of the SSC for which

the teach commands are valid

(TI Select - Teach-In Select)

Mode of the selected Teach

channel

Shows the teach status of the

teach-in process

20/40

Rights

Unit / Allowed values

- Default (SSC1) / SSC1 /

SSC2

- Default: Default

Single Point / Window

- 0 = Idle

- 1 = SP1 Success

- 2 = SP2 Success

Frauenfeld, Switzerland

Baumer Electric AG