Douglas Dynamics SnowEx Automatixx SPEEDWING 77840-1 Інструкція з монтажу Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Снігоочисник Douglas Dynamics SnowEx Automatixx SPEEDWING 77840-1. Douglas Dynamics SnowEx Automatixx SPEEDWING 77840-1 17 сторінок.
Друкувати сторінку
A-FRAME TO BLADE ASSEMBLY
1. Align the pivot bolt hole on the A-frame with the
pivot bolt hole on the quadrant.
2. Install the pivot bolt from the top. Secure with a
1" locknut (found in the parts bag) and tighten the
locknut as much as possible while allowing the
A-frame and quadrant to pivot.
3. Move the snowplow into a normal operating
position.
Lit. No. 52308, Rev. 06
INSTALLATION INSTRUCTIONS
1" x 9"
Pivot Bolt
1" Locknut
(in parts bag)
4. Remove the protective packaging from the angle
rams.
5. Align the holes in the rod end of the angle ram
with the corresponding holes on the back of the
quadrant.
6. Install a 1" x 4" clevis pin (from the shipping
bracket) from the top down to attach each rod.
Secure the clevis pins with 1/4" x 1-1/2" cotter pins
from the parts bag.
1" x 4" Clevis Pins
1/4" x 1-1/2"
Cotter Pin
7
May 1, 2021