Douglas Dynamics DD 99494 Посібник - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник для Світильник Douglas Dynamics DD 99494. Douglas Dynamics DD 99494 6 сторінок. Strobe light kit stainless steel hopper spreaders

Друкувати сторінку

99494

INSTALLATION INSTRUCTIONS

WARNING

Do not exceed GVWR or GAWR ratings

as found on the driver-side vehicle door

cornerpost.

CAUTION

Read this document before installing the

strobe lights.

CAUTION

Use standard methods and practices when

attaching spreader and installing accessories,

including proper personal protective safety

equipment.

Spreaders with Gasoline Engine

The Accessory Bracket & Harness Kit – Gas must be

installed before the strobe lights and brackets can be

installed.

Spreaders with Hydraulic Drive

The Accessory Enclosure & Harness Kit – Hydraulic

must be installed before the strobe lights and brackets

can be installed, as shown on page 4.

Lit. No. 92945, Rev. 05

Install Brackets and Lights

1. Park the vehicle on a smooth, level, hard surface,

such as concrete. Turn the vehicle ignition to the

"OFF" position and remove the key.

2. Position the passenger-side strobe light bracket at

the rear of the hopper as shown, allowing a 2" gap

between the bracket and the hopper.

Strobe Light

Bracket

Before drilling holes, check to be sure that no

vehicle wiring or other components could be

damaged.

3. Using the bracket as a template, mark the location

of the three bracket mounting holes on the hopper.

Drill pilot holes using a #3 or 7/32" drill bit.

For 0.35 yd

and 0.7 yd

Remove the carriage bolts from the corner. Use all

three available holes to install the bracket.

4. Install the bracket to the hopper using the supplied

#10 hardware.

5. The ﬂ at washers can be used to make up space

between the bracket and the hopper side so the

bracket ﬁ ts squarely on the hopper.

6. Repeat Steps 2–4 for the driver-side bracket.

CAUTION

hopper spreaders:

August 1, 2020