Baumer CombiLyz AFI4 Інструкція з експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Вимірювальні прилади Baumer CombiLyz AFI4. Baumer CombiLyz AFI4 36 сторінок. Conductivity transmitter
Також для Baumer CombiLyz AFI4: Посібник (7 сторінок)
Друкувати сторінку
English
Programming the AFI4 / AFI5 with the FlexProgram
If user defined concentration is selected you may enter the number of
point (2...30 points) in which the media is to be calibrated.
Fill in conductivity in µS/cm and % for each point.
See example to the right.
Screen Output (when conductivity is selected in DTM setup)
Setting the temperature output range, -20...150°C (4...20 mA)
Setting the conductivity µS/cm or mS/cm output 4 ranges (4...20 mA)
The ranges set under Input will appear, however can be overwritten if
wanted.
The transmitter error signal can be directed to either temperature out-
put or conductivity output or both outputs.
Screen Output (when concentration is selected in DTM setup)
Setting the temperature output range (4...20 mA)
Setting the concentration % output 4 ranges (4...20 mA)
The ranges set under Input will appear, however can be overwritten if
wanted.
The transmitter error signal can be directed to either temperature out-
put or conductivity output or both outputs.
Screen Media screen
A product label can be entered in field "Label" e.g. Milk
and the values for the media entered in µS/cm in the two following
fields. Then the "Label" will appear on the display between the two
values (see media screens page 3)
(The colours is only informative, they will not appear on the display)
Example:
Water
Milk
CIP acid
CIP caustic
www.baumer.com
600 µS/cm
700 µS/cm
4500 µS/cm
5500 µS/cm
9000 µS/cm
11000 µS/cm
55000 µS/cm
65000 µS/cm
CombiLyz, AFI4 / AFI5
Operating Instruction
Operating Instruction: 11126179 05
Page 11 / 36