Amphenol RESMLAC 28 MG Посібник з монтажу - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з монтажу для Мережевий маршрутизатор Amphenol RESMLAC 28 MG. Amphenol RESMLAC 28 MG 15 сторінок. Ip67 rugged ethernet managed switch
Також для Amphenol RESMLAC 28 MG: Посібник з монтажу (15 сторінок)
Друкувати сторінку
Section 2
Overview
Front Panel
Display
LED Indicators
for Power
LED indicators
for Ethernet
ports
ON/OFF
switch
RESMLAC 28MG IG rev. 1.3
Amphenol
– 948, Promenade de l'Arve – B.P. 29 – 74311 THYEZ Cedex – France - +33(0)4.50.89.28.00 – www.rjswitch.com
Hardware
The switches can be mounted directly to a flat surface or to a wall. Refer to the mechanical
drawing below. Its high protected enclosure makes it able to withstand immersion (IP67
rating).
The Ethernet connections come out from rugged MIL-DTL-38999 serie III connectors for
power and fiber and with SCE Terrapin connectors for Ethernet.
The following describes the front panel, and LED indicators of the RESMLAC28MG.
The Single Power 1 and Power 2 Led indicators on the front panel provide the operative
status of the switch. Some models come with only 1 power supply, some come with 2
separate power supplies.
On models with only 1 power supply, only Power 1 LED indicator will be operational.
Once the LED is turned on, the switch is powered and ready-for-use.
This LED will be ON solid green when proper power has been applied to the unit.
Each port has 2 LEDs indicators:
•
Link / Activity (Off – there is no link, Steady Green – There is a device connected,
Flashing Green – there is data transmission)
•
Speed (Steady Green for 1000Mbps, Off for 100 and 10 Mbps)
RESMLAC28MG is equipped with an ON/OFF switch, located at the rear of
The
the unit. The ON/OFF switch has a lock apparel. To move from one position to the
other, pull and move the ON/OFF switch.
Page 4 of 15
Last Rev: 1-Feb-21