Amphenol RESMLAC 28 MG Посібник з монтажу - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з монтажу для Мережевий маршрутизатор Amphenol RESMLAC 28 MG. Amphenol RESMLAC 28 MG 15 сторінок. Ip67 rugged ethernet managed switch
Також для Amphenol RESMLAC 28 MG: Посібник з монтажу (15 сторінок)
Друкувати сторінку
Section 3
Selecting a
Site
Mounting
View of a model with 4 fibers optics TVOP ports and Type A +B brackets.
RESMLAC 28MG IG rev. 1.3
Amphenol
– 948, Promenade de l'Arve – B.P. 29 – 74311 THYEZ Cedex – France - +33(0)4.50.89.28.00 – www.rjswitch.com
Installation
As with any electronic device, you should place the switch where it will not be subject to
extreme temperatures, humidity, or electromagnetic interference that exceeds the
RESMLAC28MG's profile. Specifically, the site you select should meet the following
requirements:
•
The ambient temperature should be between -35 to 75 degrees Celsius.
•
The relative humidity is recommended to be less than 95% percent, non-
condensing.
•
Surrounding electrical devices should not exceed the electromagnetic field (RFC)
standards for MIL-STD-461.
The switches are pre-equipped with plastic or metallic caps on all ports, including power
and Ethernet.
Make sure all connectors are protected with cap or sealed plug to
ensure sealing and prevent from deterioration of the contacts.
The RESMLAC28MG Ethernet Switch can be fastened to any flat surface by mounting the
box directly or installed inside a 19'' rack. Refer to the mechanical drawings below. Make
sure to allow enough room to route your Ethernet and power cables.
Two types of brackets are available:
•
Type A for 19'' rack mounting
By default, the Ethernet switch is delivered with Type A brackets.
•
Type B for mounting on any flat surface with fixations from the rear.
6x Screws with flat and spring washer are needed to fix the brackets onto the switch.
Page 5 of 15
Last Rev: 1-Feb-21