AmpliVox AirVox SW695 Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Акустична система AmpliVox AirVox SW695. AmpliVox AirVox SW695 12 сторінок. Battery powered pa system with bluetooth
Друкувати сторінку
BACK PANEL
UHF ANTENNA CONNECTOR
16 CHANNEL DIGITAL
WIRELESS RECEIVER
BLUETOOTH
AUDIO CONTROLS
POWER SWITCH B : Press to turn ON. Power LED and
•
Battery Status Meter H will light.
•
MASTER VOLUME C : Rotate knob clockwise to
increase volume of PA to desired level.
D
LINE
/ MICROPHONE
•
TROLS : Work separately from MASTER VOLUME.
Rotate knob clockwise to increase VOLUME.
•
knob counter-clockwise for more bass or clockwise for more
treble.
•
F
LINE IN / OUT
: 3.5mm jacks for other audio devices.
Use LINE OUT when using cable to connect to the S1274
REMOTE COMPANION SPEAKER.
BATTERY CHARGER / DC IN
•
connect the PA to 110-220VAC using the supplied
power cord and AC Adapter. The battery will charge when
unit is operating with AC power, HOWEVER, the unit will
charge faster with the power switch in the "off"
position.
Charging time is about 7 hours.
The PA should be plugged in and charging when not in
use to maximize battery life. Recharging the PA only
when the battery status light is orange or red will short-
en the useful life of the batteries.
•
BATTERY STATUS METER
cates the condition of the battery.
charge immediately; Yellow/Orange – battery at 50%
should be recharged before use. Green - fully
charged.
A full charge should give you up to 10 hours of
operating time ( less if using for music).
•
I
USB CHARGING
: A 5V, 500mA charging connector
has been provided to help maintain your battery in a cell
phone, tablet or computer while in use with the PA speaker.
E
,VOLUME / TONE CON-
Turn TONE
G
: To charge the battery,
H
: The color of the light indi-
Red – battery low, re-
D
C
F
J
•
WIRED MICROPHONE INPUT
connector (this jack will accept either type microphone). If
you plug in a line level device into mic level the sound will be
loud and distorted. A microphone with an XLR connector is
typically Mic Level. A microphone with a 1/4" connector is
typically Line Level.
•
PHANTOM POWER
Microphone press button to activate circuitry.
•
EXTERNAL SPEAKER JACK
connecting to a PASSIVE SPEAKER.
M
•
SIREN BUTTON
Push and hold.
4
QUICK SET-UP GUIDE
Instructions, when this manual
cannot be found.
AUDIO CONTROLS
E
M
L
I
G
J
: Combination XLR / ¼"
K
: When using a Phantom
L
: 1/4" output jack. Use for
: Single - Variable tone @125 dB.
H
B
K