Follett EU155N Series Посібник з монтажу, експлуатації та обслуговування - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з монтажу, експлуатації та обслуговування для Диспенсер для води Follett EU155N Series. Follett EU155N Series 20 сторінок. Ice and water dispensers
Також для Follett EU155N Series: Посібник з монтажу та обслуговування (20 сторінок), Посібник з монтажу, експлуатації та обслуговування (20 сторінок)

Installing remote ice machine

Correct installation of remote ice machine(s) is critical to proper performance of ice machine

and dispenser.

Check to make sure bin signal on ice machine control board is switched to 24 V connection.

Refer to installation manual packed with ice machine for important details on ice transport

tube run, ventilation requirements and other installation requirements. Failure to comply with

instructions will void warranty.

1. Position ice machine in desired location.

2. Push one end of ice transport tube(s) through hole(s) provided in side of dispenser.

3. Route tube into ice tube bracket inside dispenser and engage bracket tabs in holes located in end of ice

transport tube(s). (See drawings below.)

4. Proceed with ice transport tube installation from dispenser to ice machine in compliance with instructions

contained in ice machine installation manual packed with ice machine.

Ice tube retainer bracket

thermostat

(automatic load units only) ––––––––––––––––––––––––––––––

ice tube

Front view

25mm

ice tube

Side view

Tabs in ice tube

retainer bracket

engage holes in ice

tube and hold tube

in place

EU155N Ice and Water Dispensers

thermostat