Comco AccuFlo AF10-E Посібник з експлуатації обладнання - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з експлуатації обладнання для Електроінструмент Comco AccuFlo AF10-E. Comco AccuFlo AF10-E 14 сторінок. Micro-abrasive blaster

Друкувати сторінку

For easier maintenance there are two counters on

the front panel.

The CYC counts the number of blast cycles on the

AccuFlo (each time the PowderGate® valve opens.)

Abrasive type and blast pressure will impact

maintenance frequency, but typical configurations

will last more than 250,000 cycles before needing

maintenance.

The HRS counter records the number of blast hours

(i.e. actual time the modulator has operated.)

Your maintenance requirements may vary with your

application.

The modulator should be replaced after 5000 hours

of operation.

To replace the AccuFlo® AF10‐E modulator:

• Disconnect 3 colored tubes from the modulator

and the electrical plug from front panel.

• Remove the two screws holding the modulator

to the bracket using a Phillips screwdriver.

• Install the new modulator in reverse order,

making sure the two grommets remain in the

bracket.

Maintenance Counters

AccuFlo® Modulator

MODULATOR

MB2250‐1 (115V)

MB2250‐2 (230V)

Tech Support: 1‐818‐841‐5500