DPS Turbonator VGT Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Контролер DPS Turbonator VGT. DPS Turbonator VGT 13 сторінок.

____________________________________________________________________________

1. Locate the wires shown in Figure 4, which have the relay and two loose wires, with PIN

labels.

2. Locate the ECM on the drivers side of the engine, remove bolt, disconnect the connector

from the ECM, which contains the pins shown on the provided wires.

3. On the inside of the plug at the pin location there is a small piece of plastic to keep water

out. Use needle nose pliers and pull the plastic piece out.

4. Push the two new pins into the connector until they click.

5. Plug connector back into the ECM and tighten bolt.

Revision 1.3

Revision Date 1/28/2020

www.dieselpowersource.com

Exhaust Brake Wiring

2003-2007 Dodge 5.9 Common Rail

Turbonator® VGT Controller