DPS Turbonator VGT 설치 매뉴얼 - 페이지 5

{카테고리_이름} DPS Turbonator VGT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DPS Turbonator VGT 13 페이지.

____________________________________________________________________________

1. Locate the wires shown in Figure 4, which have the relay and two loose wires, with PIN

labels.

2. Locate the ECM on the drivers side of the engine, remove bolt, disconnect the connector

from the ECM, which contains the pins shown on the provided wires.

3. On the inside of the plug at the pin location there is a small piece of plastic to keep water

out. Use needle nose pliers and pull the plastic piece out.

4. Push the two new pins into the connector until they click.

5. Plug connector back into the ECM and tighten bolt.

Revision 1.3

Revision Date 1/28/2020

www.dieselpowersource.com

Exhaust Brake Wiring

2003-2007 Dodge 5.9 Common Rail

Turbonator® VGT Controller