DPS Turbonator VGT 설치 매뉴얼 - 페이지 13

{카테고리_이름} DPS Turbonator VGT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DPS Turbonator VGT 13 페이지.

Bending instructions (only if necessary):

Route the new copper tubing from the pressure sensor

fitting to the fitting installed in exhaust housing. Be

careful not to kink the tube. Use 1.0-1.5 inch PVC pipe as

a mandrel to bend the tube. Once the tube is bent, do

not try to straighten or it could kink.

If the tubing is too long, it can be coiled around a pipe to

shorten as needed.

Revision 1.3

Revision Date 1/28/2020

Turbonator® VGT Controller