DPS Turbonator VGT Kurulum Kılavuzu - Sayfa 13
Kontrolör DPS Turbonator VGT için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DPS Turbonator VGT 13 sayfaları.
Bending instructions (only if necessary):
Route the new copper tubing from the pressure sensor
fitting to the fitting installed in exhaust housing. Be
careful not to kink the tube. Use 1.0-1.5 inch PVC pipe as
a mandrel to bend the tube. Once the tube is bent, do
not try to straighten or it could kink.
If the tubing is too long, it can be coiled around a pipe to
shorten as needed.
Revision 1.3
Revision Date 1/28/2020
Turbonator® VGT Controller
www.dieselpowersource.com