DPS Turbonator VGT 설치 매뉴얼 - 페이지 6
{카테고리_이름} DPS Turbonator VGT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DPS Turbonator VGT 13 페이지.
페이지 인쇄______________________________________________________________________
1. Locate the ECM on the drivers side of the engine, remove bolt, disconnect the connector
from the ECM.
2. On the inside of the plug at pin 20 there is a small piece of plastic to keep water out.
Use needle nose pliers and pull the plastic piece out.
3. Push the Yellow single wire into the plug from the wire side, until it clicks.
4. Plug connector back into the ECM and tighten bolt.
Revision 1.3
Revision Date 1/28/2020
www.dieselpowersource.com
Exhaust Brake Wiring
1998.5-2002 Dodge 5.9 VP44
Turbonator® VGT Controller