AMQ Cluvo Посібник - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник для Внутрішнє оздоблення приміщень AMQ Cluvo. AMQ Cluvo 13 сторінок.

Друкувати сторінку
Resetting the Base
1.
Turn the knob counterclockwise to lower the base until lowest height, then release the knob.
Then turn the knob counterclockwise for 5 seconds, until LET GO OF KNOB BASE IS READY
FOR RESET is shown on LED display.
2.
Release the knob. TURN KNOB & HOLD UNTIL TABLE REACHES LOWEST HEIGHT AND
RESETS will show on LED display.
3.
Continue to turn the knob counterclockwise until SUCCESSFUL is shown on LED display. Then
return to the normal LED display.
Hard Reset for E01/E02
1.
If COLUMN OVERLOAD E01/E02 ERROR CODE PRESS KNOB TO CONTINUE shows on LED display,
press the knob until COLUMN OVERLOAD (STEP 1) PLEASE CHECK TABLELOAD PRESS KNOB
TO CONTINUE shows on LED display.
2.
Press the knob again until COLUMN OVERLOAD (STEP 2) RESET REQUIRED TURN KNOB
ANTI-CLOCKWISE AND HOLD FOR 5 SECONDS shows on LED display.
3.
Confirm load is lower than maximum load capacity, and turn the knob counterclockwise for 5
seconds, until COLUMN OVERLOAD (STEP 3) LET GO OF THE KNOB BASE IS READY FOR RESET
shows on LED display.
4.
Release the button. COLUMN OVERLOAD (STEP 3) TURN KNOB & HOLD UNTIL TABLE REACHES
LOWEST HEIGHT AND RESETS shows on LED display.
5.
Turn the knob counterclockwise until reset is complete.
6.
If the reset is unsuccessful, UNSUCCESSFUL will display on LED for 1 second, then COLUMN
OVERLOAD (STEP 4) CONTACT YOUR DEALER OR EMAIL [email protected] will display on LED.
7.
If STEP 4 is displayed on LED, try turn the knob counterclockwise for 5 seconds until STEP 3
displays on LED, then retry the resetting process.
Hard Reset for E07/E08
1.
If COLUMN SIGNAL ERROR E07/E08 ERROR CODE PRESS KNOB TO CONTINUE displays on LED,
press the knob until COLUMN SIGNAL ERROR (STEP 1) PLEASE CHECK CABLE CONNECTION
PRESS KNOB TO CONTINUE display on LED.
2.
Press the knob until COLUMN SIGNAL ERROR (STEP 2) RESET REQUIRED TURN KNOB
ANTI-CLOCKWISE AND HOLD FOR 5 SECONDS display on LED.
3.
Confirm the cable connection is correct, then hold the knob for 5 seconds until COLUMN SIGNAL
ERROR LET GO OF KNOB BASE IS READY FOR RESET displays on LED.
4.
Release the knob. COLUMN SIGNAL ERROR (STEP 3) TURN KNOB & HOLD UNITL TABLE REACHES
LOWEST HEIGHT AND RESETS displays on LED.
5.
Turn the knob counterclockwise until reset is complete.
6.
If the reset is unsuccessful, UNSUCCESSFUL will display on LED for 1 second, then COLUMN
SIGNAL ERROR (STEP 4) CONTACT YOUR DEALER OR EMAIL [email protected] will display
on LED.
7.
If STEP 4 is displayed on LED, try turn the knob counterclockwise for 5 seconds until STEP 3
displays on LED, then retry the resetting process.
Hard Reset for H01
1.
If CONTROLLER OVERHEAT H01 ERROR CODE LET HANDSET COOL DOWN-TRY LATER displays
on LED, wait for a while before operating the handset. The LED display will work normally and
exit the protection mode.
Cluvo User / Troubleshooting Guide | 11
amqsolutions.com