Dragonfly DFM-TAB-106 Посібник з монтажу - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник з монтажу для Проекційний екран Dragonfly DFM-TAB-106. Dragonfly DFM-TAB-106 17 сторінок. Dfm-tab screens
Також для Dragonfly DFM-TAB-106: Посібник користувача (8 сторінок)
Друкувати сторінку
DFM-TAB Installation Manual
10. Troubleshooting
Dragonfly screens are designed to function trouble-free for years of enjoyment. Most problems occur due to simple
issues. If you have trouble, check the installation while reviewing all instructions. Some of the most common issues
and solutions are also listed below. If you continue to have trouble, please contact an authorized Dragonfly dealer,
or Dragonfly support at [email protected] or (866)838-5052.
Issue
Screen does not react to
any form of control.
Viewing surface is too
high or too low.
IR control does not work
but other modes do.
11. Specifications
Specifications
Screen Material / Gain:
Frame Construction:
Unit of Measure:
Dimensions:
Weight:
Comparable Products:
Motor:
Pg. 14
Solution
•
If the screen is repeatedly reversed while in motion, it may stop moving and
reacting to any control method. This is a safety feature that keeps the motor
from overheating. If this occurs, stop testing for a moment and unplug the
power cord. Wait about 5 minutes, and plug the screen back in.
•
Check the film screen power cable and receptacle. The receptacle may not be
correctly wired, or may not be powered. Use a voltmeter to check for power
and that polarity is correct.
•
Try disconnecting any control cables and using the manual control switch
on the bottom left side of the screen housing. If this works, check the normal
control method for operation for problems. Check the wiring and control codes
being used, or consult with the controller manufacturer to confirm that all
settings are correct. If this doesn't work, check power as indicated above.
•
See Section 7. Screen Adjustments.
•
Change the batteries in the remote. (2x AAA alkaline)
•
Try using the remote at different ranges and angles. There may a lot of
interference in the room, or the line of sight from the remote to the IR receiver
is being obscured. The IR receiver extension cable may be necessary. See
Section 6. Control Setup.
•
If using the extended IR receiver, check the connection and the wire leading
into the connection port for damage, and make sure the plug is pushed in
completely. Make sure the location of the remote receiver can "see" the
commands sent by the remote from the normal area of use.
PVC and fiberglass woven inner layer/ .8 Gain (HC), 1.0 Gain(MW)
Aluminum Alloy, white
Each
See Section 12. Dimensions and Weight
See Section 12. Dimensions and Weight
Draper Silhouette/Series E, Da-Lite Contour Electrol, Vutec Lectric IRF
120V AC/.85A
© 2013 Dragonfly