Draper 83611 Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Draper 83611. Draper 83611 20 сторінок. Biscuit jointer
Також для Draper 83611: Посібник (20 сторінок)

Друкувати сторінку

BASIC BISCUIT JOINTER OPERATIONS

IMPORTANT: Make sure that the mains voltage

matches the voltage stated on the machines rating

plate.

NOTE: Remove the plug from the socket before

carrying out adjustment, servicing or maintenance.

8.1 ON/OFF LOCKING SWITCH – FIG. 1

To switch the biscuit jointer "ON" push the switch

button

towards the front of the machine.

Pushing it all the way forward will cause the button to

lock in place, for extended use.

To release the switch, press the back half of the button

in towards the machine body.

The switch will disengage and spring back to the

"OFF" position.

NOTE: Before plugging the Biscuit Jointer in, ensure

the switch is NOT locked in the "ON" position.

8.2 BLADE DEPTH SELECTION – FIG. 2

The biscuit jointer has three depth settings which are

selectable using knob

The three standard settings correspond to the three

standard sizes of biscuits available:

0 = No.0 Biscuits.

10 = No.10 Biscuits.

20 = No.20 Biscuits.

NOTE: This biscuit jointer has a fourth setting (M).

This depth is the maximum depth capacity of the

machine and is only possible with a new blade fitted

and backing out the fine adjustment screw. This

setting will not be necessary for most biscuit jointing

operations and it is recommended that the operator

use only the 0, 10, 20 settings.

8.3 HEIGHT/ANGLE ADJUSTMENT – FIG. 3

The position and angle of the biscuit can be set up

using the guide.

Loosen both levers

or down to adjust the height. Lock with both levers

The angle is also adjustable by loosening lever

Tilt the front rest

the angle between 45-135º. When set, lock lever

and indicated by arrow

and slide front rest

. Use the guide scale to indicate

FIG.1

FIG.3

FIG.2