Draper 89512 Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Дриль. Draper 89512. Draper 89512 20 сторінок. Sds+ rotary hammer drill
Друкувати сторінку
8. PREPARING THE HAMMER DRILL
8.1 BATTERY PACK CHARGING –
FIGS. 1 – 2
This power product is supplied "naked";
without battery pack or charger.
Compatible batteries, chargers and
accessories are available through
Draper Tools stockists.
● Consult the table on page 11 of
these instructions for a guide to
the available battery packs and
chargers compatible with this product.
Important: Only Draper designated battery packs
and chargers can be used in conjunction with this
product. Use of any other third party battery
packs/chargers with this product is considered
misuse and will invalidate the product's warranty.
Once connected to the mains supply recharging of
the battery pack can be left generally unsupervised
requiring minimal attention. Complex circuit
construction monitors the battery pack condition
adjusting the recharge current to suit. When the
recharge cycle is complete and to maintain the full
capacity a low output current will continue as
required.
Warning!
● Check the condition of the charger and
battery prior to each charge. If there is
any sign of damage then do not
commence charging, seek advice from
Draper Tools.
To charge the battery pack
To release the battery pack:
– Press the battery pack release button
– Plug the battery charger unit
– The green LED
– Slide the battery pack into place ensuring the battery terminals and the charger terminals make
a good connection Fig.2.
– After a few seconds delay the red LED
Warning!
● Ensure battery pack is connected correctly. (Fig.2). Sliding the battery pack on
incorrectly may cause damage to the battery/charger.
– When the battery pack is fully charged, the green LED
Warning!
● If the indicator lights fail to illuminate during the charging cycle, unplug the charger
from the power supply socket outlet and replace the battery pack.
, it must first be removed from the tool.
into a 230V/AC 13amp, three pin socket.
will stay lit to show the charger has power.
FIG.1
FIG.2
and gently slide the battery pack off (Fig.1).
will light to show the battery pack is being charged.
- 12 -
will light.