Draper 89512 Посібник користувача - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник користувача для Дриль. Draper 89512. Draper 89512 20 сторінок. Sds+ rotary hammer drill

9. BASIC OPERATION

9.1 SDS + SYSTEM – FIGS.4 – 5

The tool holder

the need for a chuck key.

– Pull collar

back.

– Insert the bit. It may be necessary to rotate the

bit to ensure it engages correctly.

– Release the collar to lock the bit in place. Check

by pulling the bit to see if it's firmly seated.

Important: Always clean and lightly grease the tool

shaft before inserting into the chuck.

Take care that the dust protection cap is not

damaged. Allowing dust and debris inside the holder

will cause problems in the future.

– To remove a drill bit, slide the collar

rear and pull out the tool.

9.2 ROTATIONAL DRIVE SELECTION –

FIG.6

The forward/reverse drive selector switch

determines the direction of rotation of the drive, i.e.

clockwise or anticlockwise.

To alter the direction of rotation:

– Stop the machine and push switch

or right.

– When the direction switch is pushed to the left,

the drive will rotate clockwise.

– When the switch is pushed to the right, the drive

will rotate anticlockwise.

– Before operation, check that the switch is set in

the required position. Do not change the

direction of rotation until the driver comes to a

complete stop.

clamps SDS+ drill bits without

FIG.4

to the

FIG.5

to the left

FIG.6

- 14 -