Draper 70297 Посібник користувача - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник користувача для Пила. Draper 70297. Draper 70297 20 сторінок.
Друкувати сторінку
8.
PREPARING THE RECIPROCATING SAW
8.1 BATTERY CHARGING – FIGS. 1 – 2
Check the mains voltage. Make sure the voltage of
the power source is the same as the voltage
specified on the rating plate of the charger unit.
Plug your mains plug into the power source.
The green LED indicator (A) will blink indicating
stand-by mode.
Insert battery pack into battery compartment of the
charger. The red LED indicator (B) will light solid.
This indicates that the battery pack is being fast
charged automatically.
When the battery pack is fully charged, the red
LED indicator will turn off and the green LED will
illuminate solid.
Remove the battery pack from the charger and
unplug.
IMPORTANT CHARGING NOTES:
Longest life and best performance can be obtained
if the battery pack is charged when the surrounding
air temperature is between 18°C (65°F) and 24°C
(75°F). DO NOT charge battery pack in an air
temperature below 4.5°C (40°F), or above 40.5°C
(105°F). This is important and will prevent serious
damage to the battery pack.
The charger is designed to fast charge the battery
pack between 0°C (32°F) AND 45°C (113°F). If the
battery pack, when inserted, is too cold or too hot,
the charger will not charge. The green LED and the
red LED will blink alternatively and continuously to
indicate this situation. Once the air temperature is
within tolerance, the fast charging will begin.
Charger light indicator
LED indicator
Green
Red
Blinking light
No light
No light
Solid light
Solid light
No light
Blinking light
Blinking light
No light
Blinking light
Situation
Stand by.
Charging.
Charging is complete.
Battery pack is too hot or cold (charging will begin automatically
when battery reaches correct charging temperature).
Damaged or faulty battery pack.
– 14 –
FIG. 1
(B)
(A)
FIG. 2