Draper 70297 Посібник користувача - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник користувача для Пила. Draper 70297. Draper 70297 20 сторінок.
Друкувати сторінку
9.
BASIC RECIPROCATING SAW OPERATIONS
9.1 BLADE INSTALLATION –
FIGS. 3 – 4
Turn and hold the spring-loaded quick release
blade clamp (2) counter-clockwise.
Insert the blade into the slot (2.1) of blade clamp.
Release the blade clamp to lock the blade.
Check that the blade is secure before operating
the saw.
Warning!
When changing a blade immediately after
operation, allow the blade to cool before removing
to avoid possible burning.
9.2 SWITCH AND VARIABLE STROKE
RATE CONTROL – FIG. 5
Your reciprocating saw is equipped with a safety
lock and a trigger switch to turn the saw on and off,
and to control the speed.
To start the saw, ensure that the safety lock is
pushed towards the body of the tool from the
"unlocked lock" decal on the side of the switch,
press the variable speed trigger switch (8).
To stop the saw, release the trigger switch.
To vary the stroke rate, simply increase or
decrease the pressure on the trigger switch.
The tighter the trigger switch is pressed, the higher
the speed.
9.3 GENERAL CUTTING
Warning!
Before use, always check to see that the trigger is
actuated properly and returns to the off position
when released.
Warning!
When sawing into walls or floors you may
encounter electrical wiring. Sawing into a "live" wire
will cause electric shock. Always check with a
metal/voltage detector that there are no hidden
hazards such as electrical cables, water or gas
pipes running below the surface.
–
Make sure the workpiece is firmly anchored.
Clamp the workpiece to prevent slipping or
moving while cutting.
–
Use the appropriate type and size of blade for
the workpiece material and size.
(2.1)
(2)
FIG. 3
FIG. 4
FIG. 5
– 15 –
(8)