Alemlube O30060 Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Водяний насос Alemlube O30060. Alemlube O30060 17 сторінок. Oil pump

To modify the correction factor in field follow this procedure

Wait for the meter to go standby.

Reset the resettable total.

Start dispensing into a measuring glass.

Stop dispensing when over 5 Litres of volume is reached, read out

the actual value. The volume that is displayed on the LCD is the

Display Value, not the Actual Value which may be slightly higher.

For example, in the figure on the right, the Display Value is 18.96

while the Actual Value is 20.75.

Press the MOVE key. Keep it pressed until it shows as the right

fig., with the digit flashing in

go the next digit so that the Actual Value can be input.

Make sure the correction factor is right and then press the

MOVE key. Keep it pressed until calibration is finished and the

factor is save. The meter will then return to be on standby.

NSW/ACT

QLD/PNG

TEL: (02) 9939 0711

TEL: (07) 3889 8480

FAX: (02) 9939 0411

FAX: (07) 3889 8490

OWNER'S TECHNICAL MANUAL

Oil Transfer Kit with Meter & Trolley



zone. Press the MOVE key to

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

Visit our website at

www.alemlube.com.au

SA/NT

TEL: (08) 9209 3066

TEL: (08) 8241 7111

FAX: (08) 9209 3933

FAX: (08) 8241 7011

www.alemlube.co.nz

O30060

TEL: (09) 447 1007

FAX: (09) 447 1008