AND UA-1020 Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Монітор артеріального тиску AND UA-1020. AND UA-1020 20 сторінок.
Також для AND UA-1020: Картка швидкого старту (2 сторінок)

Друкувати сторінку

Before measurement, read "Notes for Accurate Measurement" on page 12.

Normal Measurement

Place the cuff on the arm (preferably the left arm).

Sit quietly during measurement.

Press the

START

All of the display segments are displayed.

Zero (0) is displayed blinking briefly.

The display changes, as indicated in the

figure at the right, as the measurement

begins. The cuff starts to inflate. It is normal

for the cuff to feel very tight. A pressure bar

indicator is displayed, on the left edge of the

display, during the inflation.

Note: If you wish to stop inflation at any time,

press the

When inflation is complete, deflation starts

automatically and

indicating that the measurement is in

progress. Once the pulse is detected, the

mark blinks with each pulse beat.

Note: If an appropriate pressure is not obtained, the

device starts to inflate again automatically.

"Measurement

Pressure" on the next page.

When the measurement is complete, the

systolic and diastolic pressure readings

and pulse rate are displayed.

The cuff exhausts the remaining air and

deflates completely.

Press the

START

After one minute of non-operation,

the device will turn off automatically.

Note: Allow at least three minutes between

measurements on the same person.

Measurements

button.

button again.

START

(heart mark) blinks,

avoid

re-inflation,

with

button to turn the device off.

segments displayed

see

the

SET

Systolic pressure

Diastolic pressure

WHO classification

English 10

At heart level

Press

All of the display

Zero display

Starts inflation

Pressurizing

Measurement

in progress

Pulse rate

Exhausts remaining

air automatically

START