Forms + Surfaces levele Інструкція з монтажу Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Освітлювальне обладнання Forms + Surfaces levele. Forms + Surfaces levele 7 сторінок. Elevator interiors with lightplane

Друкувати сторінку
LEVELe
ELEVATOR INTERIORS WITH LIGHTPLANE
®
STEP BY STEP
1
Center of Side Wall
Panels
Paper Template
Provided
Cab Canopy
Masking
Tape
Ceiling Location
Temporarily attach provided paper template
for ceiling installation.
•
Center and level paper template on wall.
•
Using center punch, mark holes as indicated
on template.
4
Masking
Tape
Side
Front Wall
Wall
or COP
Front Corner
Reveal
Finished Floor
SIDE
Install (2) Front Reveals.
•
Position Front Reveals and install using
factory installed VHB tape.
Note: Detail is inside view of front corner.
T 1.800.451.0410 | F 412.781.7840 | www.forms-surfaces.com
© 2017 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
2
Drill holes to insert the U-bolts.
•
Remove the template and drill eight 3/8"
diameter holes into cab shell where
marked with center punch.
5
REAR
SIDE
Install Base Cleats.
•
Using the provided 3.5" spacers for
height, position the Base Cleat on the
center of the rear wall.
•
Ensure the Base Cleat is level before
proceeding.
•
Secure the Base Cleat with the provided
self-drilling screws.
•
Repeat for the remaining side walls.
•
Note: The standard base height is 3.5".
•
Custom-sized spacers will be provided for
custom base heights. Please reference
your shop drawings for proper installed
height.
3.5" Spacer
Base Cleat
Finished Floor
REAR
INSTALLATION INSTRUCTIONS
3
Finished Floor
SIDE
REAR
Install (2) Corner Reveals.
•
Position Corner Reveals and hold them in
place with masking tape.
•
Cover no more than 1/8" of the reveal with
tape.
6
Base Cleat
1/4"
End
Point
Mark
1/2" Spacer
REAR
SIDE
Install Base Supports.
•
Determine the location of the left- and
right-most Base Supports.
•
Start at the center point of the cab wall,
measure half the length of the Base Facing
in each direction and mark the end points.
•
Install the left- and right-most Base Supports
approximately 1/4" from your markings and
every 18" - 24" in between.
•
Base Supports should be flush with the
bottom of the Cleat.
page 2 of 7 | 10-16-17
Masking
Tape
Rear Corner
Reveal
Base
Support