Anden DH55A77 Посібник з монтажу та експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Контролер Anden DH55A77. Anden DH55A77 9 сторінок. Dehumidifier control

REQUIRED COMPONENTS

• 18-22 gauge wire (field supplied), 4 wires required, run new cable as needed.

• (2) #8 x 1-1/2" mounting screws (supplied)

• (2) Anchors (supplied)

1. Level the back plate on the wall and mark the mounting holes and wire access location on the

wall.

2. Drill two 3/16" mounting holes and a 3/4" wire access hole. See FIGURE 3.

3. Install the drywall anchors flush with the wall surface. Note: Mounting holes on the back plate

are designed to fit on a horizontal J-box.

4. Run a 4-wire cable from the dehumidifier to the wall mount location and through the square

hole in the back plate.

5. Secure the back plate to the wall using the two #8 x 1-1/2" screws.

WIRING A77 WITH DEHUMIDIFIER MODELS A70, A95, A95F, A130, A130F, A210V1 AND A320V1

1. Disconnect power to the

dehumidifier and HVAC system.

2. Remove the wiring access

cover next to the control on the

dehumidifier. See FIGURE 4.

3. Wire the Model A77 to the

dehumidifier as shown in

FIGURE 5.

4. Ensure the NO/NC switch on the

dehumidifier control is set to NO.

See FIGURE 5.

FIGURE 5 – MODEL A77 WIRING WITH DEHUMIDIFIER MODELS

A70, A95, A95F, A130, A130F, A210V1, A320V1 AND A320V3

+ - A B

C/-

R/+

FIGURE 4 – WIRING ACCESS COVER LOCATION

CONTROL

WIRING ACCESS

COVER

CONTROL

PANEL COVER

FILTER ACCESS DOOR

ODT

Remote

Sensor

MODEL A77

CONTROL

90-1884

90-2490