comoc CM1500 V Використання та обслуговування вручну - Сторінка 13

Переглянути онлайн або завантажити pdf Використання та обслуговування вручну для Підлогова машина comoc CM1500 V. comoc CM1500 V 14 сторінок.

Check the condition of the abrasive pad.

If the machine has been resting too long on the abrasive pad the pad may

have been permanently deformed. This will cause the machine to vibrate. If

the pad is ruined or worn then it must be replaced with a new pad.

To replace the pad consult the paragraphs: "REMOVING THE PAD" and

"INSTALLING THE PAD".

The machine has an amperometric safety switch located behind the handlebar

that cuts off power to the brush motor whenever a predetermined load is

exceeded. To give current back to the motor you must press the push-button.

If the switch continues to cut off power then you must call your nearest

COMAC service center.

The machine has a device that checks the state of wear of the motor brushes.

The motor brushes must be replaced when the red signal lamp turns on (see

the figure).

This procedure must be done by qualified personnel from a

COMAC service center.

WARNING! Ask for service from a COMAC service center

whenever you encounter any other malfunction.

CHECKING OPERATION