Dremel 3D40 Idea Builder Посібник

Переглянути онлайн або завантажити pdf Посібник для 3D-принтери Dremel 3D40 Idea Builder. Dremel 3D40 Idea Builder 4 сторінки. Clogged heatsink tube replacement
Також для Dremel 3D40 Idea Builder: Посібник із швидкого старту (2 сторінок), Інструкція (5 сторінок), Інструкція з обслуговування (2 сторінок)

Друкувати сторінку

WARNING

Read the Dremel 3D40 manual and these

instructions before replacing a clogged

heatsink tube in your Dremel 3D40. Failure to comply with the

warnings and instructions may result in fire, equipment damage,

property damage, or personal injury.

Always unplug Dremel 3D40 from its power before performing

any service procedures. Failure to do so may result in personal

injury and equipment damage.

Use only Dremel approved materials and components. Use of

object materials, or 3D objects other than Dremel approved object

materials and genuine Dremel components may void warranty.

Repairs on the Dremel 3D40 may require the use of special tools

(pulling devices and bearing press). Authorized repair centers have

trained repair technicians and equipment necessary to perform

these repairs.

For the location of the repair center near you, please call 1-844-

4DRML3D (1-844-437-6533) Monday thru Friday, 8AM to 6PM CST.

Or, look on our web site at www.Dremel3D.com and follow the link

for 'Support'.

CONTINENTAL UNITED STATES

Dremel Service Center

4915 21st Street

Racine, WI 53406

Phone: 1-844-4DRML3D

CAUTION

Use proper anti-static precautions when

performing this replacement. Discharge

static electricity before beginning. Work on a static-free sur-

face.

This document will outline the steps necessary to clear a

clog in the heatsink tube assembly caused by the filament

bulging up inside the tube. If the filament becomes clogged,

neither loading nor unloading will be possible. Tube clogging

can occur by either using an old filament that's kept in the

open for a longer duration or from 3rd party filaments with

lower transition temperatures.

Tools Required:

• Scissors

• 2mm Hex wrench (Allen key)

• 2.5mm Hex wrench (Allen key)

• 3/32 inches Flathead screwdriver

• T10 Torx screwdriver (no longer than 4 inches)

3D40 Clogged Heatsink Tube

Replacement

CANADA

Giles Tool Agency

47 Granger Ave,

Scarborough, ON

M1K 3K9, Canada

Phone:1-416-287-3000

West Coast Tool

4008 Myrtle Street

Burnaby, B.C. V5C 4G2

Phone: 1-604-873-5394

PRE-SERVICE PREPARATION

Step 1: Bring Printer to Safe State for Service

a. Turn on the printer, and verify that the temperature icon

reads cool (blue). If it is not blue, allow adequate time

for the nozzle to cool until the icon reads blue.

b. Turn off the printer.

c. Unplug the printer.