Dremel 3D40 Idea Builder Посібник - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник для 3D-принтери Dremel 3D40 Idea Builder. Dremel 3D40 Idea Builder 4 сторінки. Clogged heatsink tube replacement
Також для Dremel 3D40 Idea Builder: Посібник із швидкого старту (2 сторінок), Інструкція (5 сторінок), Інструкція з обслуговування (2 сторінок)

Step 4: Nozzle Assembly Removal

a. Unscrew the nozzle assembly screw with 2mm Hex

wrench as shown in the picture below. Please ensure

that the screw once fully unscrewed, should still be left

inserted in the hole.

b. Unscrew the Torx screws that hold the fan baffle assem-

bly and pull down the assembly as shown in the picture

below.

c. Use flathead screw driver to disconnect heater wires

from extruder circuit board. Gently pull the wires out of

the green terminal block.

d. Unplug the thermocouple connector (white) from the ex-

truder circuit board as shown in picture below.

e. Push down nozzle tube and pull from bottom. (Note:

Ensure that sufficient time has been given for the nozzle

to cool). Grab the block heater as shown in the picture

to pull the nozzle assembly gently. Then, use your fin-

gers to straighten any bent wires and pull straight down

through the (encircled) cavity to remove the nozzle as-

sembly as shown below.