Electrolux C260R Посібник з експлуатації - Сторінка 39

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Вентиляційна витяжка Electrolux C260R. Electrolux C260R 41 сторінка. Hydro-extractor
Також для Electrolux C260R: Посібник з експлуатації (24 сторінок), Посібник з експлуатації та встановлення (20 сторінок)

Service

manual

• Remove the bolts around base of outer casing.

Lift outer casing and control unit straight

upwards.

• Remove the three or four nuts securing the

bushing. Lift the motor straight upwards.

• Replace the two rubber bushings.

When you replace the upper bushing, do not

remove the supporting journal from the motor. It

can be difficult to adjust when it is put back.

Instead, remove the old bushing by cutting it off.

Make a cut in the new bushing as illustrated and

put it in place on the supporting journal. The

vibration from the extractor causes the surfaces

of the cut to vulcanise together after it has been

in use a while.

• C240R

- Position supporting journal in recess in base

plate and loosely tighten the three nuts above

the bushing.

• C260R, C290R

- Position supporting journal in frame. Make sure

that the pins on both supporting journal and

frame are corrected positioned in the

corresponding holes of the lower rubber

bushing.

- Tighten the outer nuts loosely at the top of the

bushing. Use the spring washers under the

nuts.

• Reinstall the outer casing and the cables to the

automatic control unit.

• Check the drum and complete the adjustment

of the four nuts according to the instructions

under the heading "checking and adjusting the

rigidity of the drum mounting.

487 03 29 91

42. Drum

15mm

42.3