Electrolux CH120 Інструкція з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Вентиляційна витяжка Electrolux CH120. Electrolux CH120 21 сторінка. Chimney hood
Також для Electrolux CH120: Інструкція з експлуатації (20 сторінок)

Друкувати сторінку

Clearance Height

The cooker hood is designed to be fitted over a

cooking appliance at the clearance heights stated,

providing the maximum output of the appliance

beneath does not exceed the maximums quoted in

the Technical Specifications.

If the output of the appliance below the cooker

hood exceeds the maximum outputs quoted,

please refer to the cooker manufacturer's

installation instructions.

A minimum clearance height of 650mm

(25 1/2 ") is required when installed above a

built-in electric hob, or 700mm (27 1/2 ") when

installed above a built-in gas hob.

A minimum clearance height of 685mm (27")

is required when installed above a slot-in

electric cooker, or 787mm (30 1/2 ") when

installed above a slot-in gas cooker.

When installed between adjoining wall

cabinets, the wall cabinets must not overhang

the hob and the distance between the

underside of the cabinet and the worktop must

be 450mm. If the height of the wall cabinet is

less than 450mm, a gap of 50mm must be

maintained either side of the hob.

This cooker hood must not be installed above

a cooking appliance with a high level grill.

Fitting the Wall Brackets

Draw a vertical line on the wall from the

centre of the cooking appliance up to the

ceiling, using a spirit level and marking pen.

This is to ensure the correct vertical

alignment of the appliance.

Draw a horizontal line through the vertical

at 270mm. Mark the centre positions for

the lower bracket fixing screws (1) at

110mm either side of the vertical line (screws

not supplied).

Ensure that the distance between the

lowest point of the hood and the cooking

appliance beneath meet the clearance

requirements quoted above.

Draw a horizontal line through the vertical

at 45mm from the ceiling or from the

maximum height of the chimney. Mark the

centre positions for the upper bracket

fixing screws (2) at 80mm either of the

vertical line (screws not supplied).

A: Built-in Electric Hob:

B: Built-in Gas hob:

C: Slot-in Electric Cooker: 685mm minimum clearance

D: Slot-in Gas Cooker:

Hob

650mm minimum clearance

700mm minimum clearance

787mm minimum clearance